Product Description Want create site? Find Free WordPress Themes and plugins.Filament run out detector for 1.75mm filament (case is manfuactured out of clear injection molded plastic) fully assembled internal microswitch senses end of filament onboard LED shows when filament is present cable included arrow stamped on the module to show direction of filament for correct operation Operation: Supply 3.3-5v to Pin 1 Gnd to pin 2 The module outputs to Pin 3 When filament is present (internal microswitch is depressed): Onboard LED is on Signal Pin 3 outputs the supply voltage (3.3-5v) When filament runs out i.e. is not present (internal microswitch is not depressed): Onboard LED is off Signal Pin 3 is tied to Gnd so 0V (Cabling diagram below is of the BLACK version) Physical Connection is a 3 pin JST XH type male socket 3 way cable included: approximately 1m long terminated with JST XH type female 3 way plugs at both ends See diagram below for dimensions Mounting holes accept M3 screws Dimensions (approximate as I find some slight variation, but pretty close and the mounting holes are 20mm apart) Did you find apk for android? You can find new Free Android Games and apps.
